Bathroom Mold Removal in Shreveport, LA

Black mold in the shower, on the ceiling, or inside the wall?

On the surface. Growth on painted ceilings, grout lines, caulk beads and window frames feeds on the steam left after showers. It comes back because the room stays damp, not because the cleaning was poor. The lasting fix is drying the room: a fan that actually vents outdoors, run long enough after each shower, plus new caulk where the old bead has gone black underneath.

Behind the tile or the sheetrock. A shower pan that has cracked, a supply line weeping inside the wall, or grout that has let water past the tile for years leaves the wall cavity wet. Signs are a soft or bulging wall next to the tub, loose tiles, paint bubbling on the other side of the wall, or a stain on the ceiling of the room below. That is a remediation job, with the wall opened under containment.

Under the vanity or behind the toilet. A slow drip from a trap or a wax ring rots the cabinet floor and the subfloor before anyone sees it. The musty smell is often the first clue.

Call (318) 666-4874

Who looks at it, and who opens the wall

Louisiana does not allow the same company to both assess and remediate mold on one property. When the mold may be inside the wall, an independent assessor checks moisture with a meter, looks behind the access panel or the vanity, and samples if there is a question about what is growing. The remediation crew then opens the wall and removes the damaged material, and the assessor comes back for a final check on larger jobs. See mold inspection and testing for how the assessment works.

How a bathroom mold removal job goes

Seal the room. Plastic over the doorway with a zip entrance, the bathroom fan and any supply vent covered, and a filtered air machine so nothing drifts into the bedroom next door.

Open up and take out. Tile backer, sheetrock, insulation or cabinet floor that the water has ruined is cut out and bagged. Studs, plates and subfloor that are still sound are cleaned and treated.

Find and fix the water. The leak behind it, whether a shower pan, a valve, a supply line or a drain, goes to a plumber before anything is closed up.

Dry, then rebuild. The cavity is dried to normal readings before new backer board, sheetrock and tile go back. A fan vented outside goes in if the room does not have one.

Removal in one bathroom usually takes one to two days once the room is sealed; the plumbing repair and the tile work add to that.

Why bathroom mold keeps coming back

Almost always because the moisture is still there. The fan vents into the attic instead of outdoors (which moves the problem upstairs: see attic mold removal), the fan is too small or never switched on, the shower curtain stays wet against the wall, or old caulk was covered with new caulk instead of being cut out. Cleaning removes what is there today; drying the room is what keeps it from returning.

What bathroom mold removal costs in Shreveport

A surface clean with the caulk cut out and replaced sits at the low end of $500 to $1,500. Removal behind the wall, with the sheetrock and insulation out, the framing treated and the cavity dried, runs $1,500 to $4,500, and the tile and sheetrock rebuild is priced separately. A bath fan vented outside is a few hundred dollars. The assessment is typically $300 to $600. Every price on the site is on the mold removal cost page.

Prices on this page are estimates from previous work. We cannot quote an exact price. The actual cost can be lower or higher depending on the job. The person who knows is the professional who will do the work. You get a written quote after we see the house.

Call (318) 666-4874   Request a callback

Getting the bathroom checked

Call (318) 666-4874 and tell us where the mold is, whether the wall feels soft, and whether the room has a fan that vents outside. If you would rather write it down, use the callback form below or the contact page. If a leak has reached other rooms, see water damage restoration; for dark growth anywhere else in the house, see black mold removal.